Ice Dispenser Tips; Cleaning The Ice Dispenser - Sears Kenmore Refrigerator Owner's Manual

i , i i ,, ,i, iJ,iu,iJ ,,u,,. , .
Automatic ice and
Water Dispenser
(continued)
Ice Dispenser Tips
1 lee cubes stored too long may develop an odd flavor Emptythe container and
return it to the proper position The ice maker wilt then produce more ice
2, Occasionally shake the container to keep ice separated
3.. tf the dispensing arm is pushed in for more than 4 minutes, the dispenser motor
may overload and stop, The overload protector will reset automatically after 3
or 4 minutes, If a large quantity of ice isneeded at one time, it is best to remove
cubes directly from the ice storage bin,
4, Certain sounds are normal when the ice maker is operating They are:
• Motor operation
, Ice being loosened from the tray
• Ice dropping into the storage bin
° Running water
, Water valve opening or closing
For more information on these operations, see "Normal Operating Sounds."
5. Stop the ice maker when cleaning the freezer or for long vacations..
6. If the ice maker isto beturned off for a long period of time, turn thewater supply
valve to the closed position.
Do not use the ice
chute as a handle when removing
or replacing the ice storage bin.
Surfaces there may be sharp.
DO NOT PUT FINGERS UP ICE CHUTE
SURFACES THERE MAY BE SHARP
MECH^NISM
Cleaning the Ice Dispenser
Clean the dispenser and ice storage bin at regular intervals, particularly before you
take a vacation or move, or if the ice dispenser sticks.
Stop ice production by lifting the wire signal arm to the "up" or OFF position
2 Remove ice storage bin by lifting up and out. Empty and carefully clean the bin
with mild detergent Do not submerge the bin while cleaning Rinse with clear
water. Do not use harsh or abrasive cleaners. Allow ice bin to dry completely
before replacing in the freezer
3 Remove ice chips and clean the shelf and chute that supports the ice storage
bin.
4 Replacethe ice storage bin Lower the wire signal arm on the ice maker to the
"down" or ON position and the ice maker will resume production
IMPORTANT; When removing or replacing the ice bin, do not rotate the auger
in the ice bin. If the auger is accidentally turned, you must realign the auger by
turning it in 90 ° turns until the ice bin fits into place with the drive mechanism.
For further instruction, see the label on the ice bucket
Remove and empty the ice storage bin if:
t An extended power failure (one hour or longer) causes ice cubes in the ice
storage bin to melt and freeze together and jam the dispenser mechanism
2 The ice dispenser is not used frequently Ice cubes will freeze together in the bin
and jam the dispenser mechanism Remove the ice storage bin and shake to
loosen the cubes
NEVER use an ice pick or similar sharp instrument to break up the ice This could
damage the ice storage bin and dispenser mechanism
Repositioning the Auger
Kenmore Ice and Water Filter (some models)
NOTE', if you purchased a refrigerator with a Kenmore Ice and Water
ease read the foilo,wincl use and care information.
This ice and water filter system filters water to your ice maker and water dispenser,
It islocated in the upper right back corner of the fresh food compartment (seeFigure
1 on the following page ).
System Startup:
Water supply does not need to be turned off, however do not use ice and water
dispenserwhile installing filter Refer to Figure t asyou complete these instructions.