Moisture Sensor; Frost Protection; Service And Repair - Bosch WTA3500 Use & Care Manual

10
Moisture Sensor
Occasionally the moisture sensors will need cleaning,
due to a build-up of a fine layer of lime scale on the
inside of the drum. This build-up of lime scale can be
easily removed by wiping the sensors, the metal
inserts in the paddles, and the inside of the drum with
a soft cloth soaked in vinegar (use white vinegar).
See Figure 10.
Figure 10.
SERVICE and REPAIR
The Bosch dryers require no special care other than
the care and cleaning noted above. If you are having
a problem with your dryer, before calling for service
please refer to Table 2, SELF-HELP section,
following. If service becomes necessary, contact your
dealer or installer or an authorized service center. Do
not attempt to repair the appliance yourself. Any work
performed by unauthorized personnel may void the
warranty.
If you are having a problem with your Bosch washer
and are not pleased with the service you have
received:
• First, please contact your installer or the Bosch
Authorized Service Contractor in your area and
explain to them why you are not satisfied. This
will usually correct the problem.
• If after working with your installer or service
person the problem still has not been resolved to
your satisfaction, please let us know by either
writing to us at,
BSH Home Appliances
2800 South 25th Avenue
Broadview, IL 60153
or, calling us at,
1-800/944-2904.
Frost Protection (WTL models only)
The WTL models, since they remove moisture by
condensing the water out of the air and then pumping
the water to drain, should never be installed in an
area subject to freezing. Also, if the dryer is to be
transported where it would be subjected to freezing
the dryer must be completely emptied of water before
transporting.
Please be sure to include, if writing, or have
available, if calling, the following information:
• Model Number
• Serial Number
• Date of Original Purchase
• Date Problem Originated
• Explanation of Problem
Also, if writing, please be sure to include a daytime
telephone number.
You will find the model number and serial number
information on the rating plate located on the inside
of the door above the lint filter. See Figure 1.