Before Using The First Time; Getting Started; Cycle Selection Chart, Table 1 - Bosch WTA3500 Use & Care Manual

BEFORE USING FOR THE FIRST TIME
Before beginning to use your dryer for the first
time:
1. Check to make sure that the voltage on which
the dryer is to operate is the same as shown
on the rating plate.
GETTING STARTED
Below, in order to get started, you will find a summary
of how to operate the clothes dryer. Also, refer to the
CYCLE SELECTION CHART, Table 1.
• Turn On the Dryer
Press the "ON/OFF" button. The indicator light
will become illuminated and the indicator above
the "START" button will begin to flash.
• Check the Lint Filter
The lint filter, located in the door, should be
cleaned after or before each load.
• Load the Dryer
Load the items in the dryer.
• Add Fabric Softener Sheet
If a fabric softener sheet is to be added it should
be done after loading the dryer.
• Close the Dryer Door
• Select Cycle Desired
See CYCLE SELECTION CHART, Table 1, and
following section titled OPERATION for program
recommendations.
• Select Additional Functions (if desired)
See following section titled OPERATION.
2. Wipe the interior of the drum with a damp
cloth.
• Press the "START" Button
The "START" indicator lamp will stop flashing and
the dryer will start. If one of the Auto-Cycles have
been selected the Duotronic system will monitor
the moisture level and display the progress of the
drying in the "Moisture Level Indicator Lights." If a
timed cycle has been selected the minutes
remaining will be displayed in the "Cycle
Countdown Display."
The cycle will continue to the end, when the
"End" indictor lamp will become illuminated. And,
if the "End of Cycle Signal" has been selected a
signal will sound. - See following section
OPERATION on how to set or turn of the "End of
Cycle" signal.
• Depress the "DOOR" Button
The door will open.
• Remove the Laundry from the Dryer
• Clean the Lint Filter
• Turn Off the Dryer
Depress the "ON/OFF" button.
5