GE JGP628 Installation Instructions Manual page 5

Installation Instructions
Installing the Cooktop Unit
Locate the electrical outlet
and the Gas Shut Off valve
beneath the cabinet,
NEVER REUSE _J
II
OLD CONNECTORS ll\
Shut Off I Electrical
WHEN INSTALLING Va,vo--' , outlot
THIS UNIT. L] I t2..Bo,ow
Countertop
Install a manual shutoff valve in the gas line in
an easily accessible location outside the cooktop.
Be sure you know how and where to shut off the
gas supply to the cooktop. Install the electrical
outlet 12" below the countertop.
I-B--_ Protect the Surface
of the Cooktop
Place a towel or tablecloth onto the
countertop. Lay the cooktop upside down
onto the protected surface.
Bottomof _ok_op
Cloth un_r Co_k_op
Attach the Adhesive Strip
(Glass Top Models Only)
Attach the adhesive strip around the maintop
glass as close to the edge as possible.
Outer edge
of glass bottom
Cooktop I.-_...._
Burner Adhesive Strips
Box to outer edge
of glass
Countertop
I-B--_Attach Brackets to Cooktop
Remove the screw from the bottom of the
cooktop. Screw the hold down bracket to the
side of the cooktop unit. Repeat for opposite
side of cooktop.
Pre-drilled
Bottom of hole
Cooktop /_O_
Foam Strips
Cooktop
I-B--_Insert Cooktop Into Cutout
Insert the cooktop centered into the cutout
opening. Make sure the front edge of the
countertop is parallel to the cooktop. Make
final check that all required clearances are
met.
Once the unit is in place, screw the hold
down bracket into the cabinet sides to
secure the unit into place.
I-_ Locate The Mounting Parts
Remove the hold down brackets from the
literature package.
5