GE JGP628 Installation Instructions Manual page 14

LP Conversion
Making the LP Conversion
cont.
Changing the Cooktop
Burner Orifices:
a. Remove the top
grates, burner caps,
burner heads and
burner bases.
b. Remove the
electrodes from the
burner base. Using a
No. 15 "Torx" head
driver bit, remove the
screws holding the
burner base in
position.
C.
V REMOVE
I THIS
ORIFICE SPUD
LOCATED THRU
THIS OPENING
Using a 7mm or 9/32" nut driver, remove the
top burner orifices. These may be accessed
through the hole in the cooktop.
NOTE: The orifices
have a spring
loaded
_--_ _RETAINER
retaining ring around RJ.G
the hex head to hold
the orifice in the nut
driver during
installation and removal. A slight amount of
force is required to push the nut driver
down over the ring.
d. Locate the LP/Propane orifices shipped
inside the literature package. They will have
a digit number and the letter "L" on the side.
(IMPORTANT: Save the orifices removed
from the appliance for future use.)
Each orifice will show a series of engraved
marks, (I, II, III or X ), located on the top.
OOOO
Units with 4 burners
Units with 5 burners
e. Install the LP/Propane orifices in their
precise locations as noted in the illustrations
above.
f. Replace the burner bases, heads, caps and
top grates. (NOTE: When re-attaching the
burner bases to glass top units, tighten
screws to a maximum of 10in.-Ibs
torque.)
g. Save the orifices removed from the
appliance for future use.
These marks denote the precise location of
each orifice to the cooktop burner.
14
continued on following page