Display Assembly; Removing The Display Assembly - Dell Inspiron 1440 Service Manual

Back to Contents Page
Display
Dell™ Inspiron™ 1440 Service Manual
Display Assembly
Display Bezel
Display Panel
Display Panel Cable
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION: To help prevent damage to the system board, remove the main battery (see
computer.
Display Assembly

Removing the Display Assembly

1. Follow the procedures in Before You
2. Remove the battery (see Removing the
3. Remove the module cover (see
4. Remove the memory module(s) (see
5. Remove the hard drive (see
6. Remove the optical drive (see
7. Remove the two screws from the computer base.
8. Remove the center control cover (see
9. Remove the keyboard (see
10. Remove the power button board (see
11. Remove the palm rest (see
12. Disconnect the camera cable from the system board connector.
13. Make note of the Mini-Card antenna cables, camera cable, and the display cable routing and remove the cables from their routing guides.
Begin.
Battery).
Removing the Module Cover).
Removing the Memory Module(s)).
Removing the Hard Drive).
Removing the Optical Drive).
Removing the Center Control
Removing the Keyboard).
Removing the Power Button
Removing the Palm Rest).
Removing the
Cover).
Board).
Battery) before working inside the