Using The Remote Control; Adjust The Image - Epson PowerLite 955W Quick Setup

4
Press the power button on the projector or remote control. The
projector beeps, and the Status light flashes blue and then stays on.
Note: To shut down the projector, press the
unplug it. You don't have to wait for the projector to cool down.
5
The default language of the menu system is English. To select another
language, press the Menu button on the projector or remote control.
Select Extended and press
Select your language and press
the menu system.

Adjust the image

1
If you don't see an image, press the Source Search button on the
projector or the remote control to select the image source.
Note: If you still see a blank screen or have other display problems, see
the troubleshooting tips on the back of this sheet.
2
To raise the image, press the foot release button and lift the front of the
projector. Release the button to lock the foot in position.
3
Turn the zoom ring to enlarge or reduce the image.
4
Turn the focus ring to sharpen the image.
5
If your image looks like
off to one side of the screen at an angle. Place the projector directly in
front of the center of the screen, facing the screen squarely. If you
can't move the projector, use the horizontal keystone slider to correct
the image.
6
Your projector automatically adjusts images that look like
but if necessary you can press the
correct it.
power button twice, then
. Select Language and press
. Press the Menu button to exit
or , you may have placed the projector
or button on the projector to

Using the remote control

Make sure the batteries are installed as shown (two AA batteries).
Turn projector
.
Access projector
Turn off projector
For more information on using the remote control, see the online User's
Guide.
Project wirelessly
Follow the steps here to connect the projector over a wireless network. You
will need the optional wireless LAN module (part number V12H418P12).
1
To install the wireless LAN module, first remove the screw as shown.
2
Connect the wireless LAN module to the USB-A (flat) port.
3
To configure your projector for wireless projection, do one of the
following:
•
If you're using the optional Quick Wireless Connection USB key
(Windows only, part number V12H005M09), press the LAN button on
or ,
the remote control. When you see SSID and IP address information
on the screen, remove the wireless LAN module and connect the
key to the projector's USB-A port. Look for the displayed message,
remove the key, and connect it to a USB port on your computer.
Follow the on-screen instructions to install the driver, then reconnect
the wireless LAN module to the projector's USB-A port. For details,
see the online User's Guide.
•
If you're not using the key, continue with the steps on the next page.
on and off
menus
display
Choose which
source to display
Navigate projector
menus
Get solutions to
common problems