GE JP200 Owner's Manual And Installation Instructions page 13

Installation of the cooktop, ge.com
Read these instructions completely and carefully.
InstallationInstruction
Besurethiscut doesnotinterferewith the cabinetstructureat thefront
,- l
5" Min.*
_[
Holddownretainer
!4 ;7
Self tappingscrew for serviceability
Max. distance of 7" when installing over GSM2100dishwasher
Suggested mounting of an approved junction box.
Install an approved junction box where it will be
easil) accessible through the front of the cabinet
where the counter unit will be located.
IMPORTAN# Thejunction box must be located
where it will allow slack in the conduit for
serviceabili_ If installing over a GSM2100
dishwasher, the center of the junction box must
be installed 5" to 7" below the cooktop lip, so it
does not interfere with the dishwasher
installation or operation.
Install the cotmter unit in the cutout opening.
IIIOT£" If theunitis beinginstalledin a blindcounter
(onewith no cabinet o pening below)or overa GSM2100
dishwasher, wkeconnections m ustbe madebeforeputting
theunit intothecutout
Secure the cooktop unit to the counter using the
side retainers and screws shipped with the unit.
• For thicker counte_s (greater than 1" thick),
hold down straps should be used to install
the cooktop. They are included with some
models, or can be ordered, GE model
number WB2K5328.
Beforeinstallingthecounterunitor movingit to
anotherlocationhavethe electricianverify:
• That your home is provided with adequate
electrical serxice,
• That the addition of the counter unit will not
oxerload the household circuit on which it is
tlsed,
,_ DANGER:Always disconnect the electrical
service to the unit before repairing or
servicing the counter unit. This can be done by
disconnecting the fuse or circuit breaker. Failure
to do this could result in a dangerous or even
fatal shock. Know where your main disconnect
switch is located. If you don't know, have your
electrician show you.
• To attach the cooktop to the counter; insert
the hold-down strap into the slots on each side
of the unit (see diagram).
• Use suitable scre_:s to attach the cooktop to
the counter as shown. The cooktop must rest
on the metal flange around the burner box.
Mountingslot
Strap
Cabine_es
)1
)1
)1
I )j
,j
Burnerboxsides
Usesuitable
fasteners for
anchoring in
cabinetsides
13