Safety Instructions - Dell XPS 8300 Service Manual

Hide thumbs Also See for XPS 8300:
Table of Contents

Advertisement

3 Ensure that the computer is turned off. If your computer did not
automatically turn off when you shut down the operating system, press
and hold the power button until the computer turns off.

Safety Instructions

Use the following safety guidelines to help protect your computer from
potential damage and to help ensure your own personal safety.
WARNING:
that shipped with your computer. For additional safety best practices information,
see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
CAUTION:
computer. Damage due to servicing that is not authorized by Dell is not covered by
your warranty.
CAUTION:
not on the cable itself. Some cables have connectors with locking tabs; if you are
disconnecting this type of cable, press in on the locking tabs before you
disconnect the cable. As you pull connectors apart, keep them evenly aligned to
avoid bending any connector pins. Also, before you connect a cable, ensure that
both connectors are correctly oriented and aligned.
CAUTION:
you begin working inside the computer.
1 Ensure that the work surface is flat and clean to prevent the computer
cover from being scratched.
2 Turn off your computer (see "Turning Off Your Computer" on page 13)
and all attached devices.
CAUTION:
computer and then unplug the cable from the network device.
3 Disconnect all telephone or network cables from the computer.
4 Disconnect your computer and all attached devices from their electrical
outlets.
5 Disconnect all attached devices from your computer.
6 Press and eject any installed cards from the Media Card Reader.
7 Press and hold the power button to ground the system board.
14
Before You Begin
Before working inside your computer, read the safety information
Only a certified service technician should perform repairs on your
When you disconnect a cable, pull on its connector or on its pull-tab,
To avoid damaging the computer, perform the following steps before
To disconnect a network cable, first unplug the cable from your

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents