Dell Latitude E6410 Service Manual page 29

Back to Removing and Replacing Parts
Heat Sink and Processor Fan
Dell™ Latitude™ E6410/E6410 ATG Service Manual
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
Removing the Heat Sink and Processor Fan
NOTE: You may need to install Adobe® Flash® Player from Adobe.com in order to view the illustrations below.
1. Follow the procedures in Before Working Inside Your
2. Remove the ATG Port Cover
3. Remove the battery
4. Remove the access panel
5. Remove the coin-cell battery
6. Disconnect the fan cable from the system board.
7. Loosen the captive screws on the heat sink.
8. Lift the edge of the heat sink that is closest to the center of the computer, and then slide the heat sink out of the computer.
Replacing the Heat Sink and Processor Fan
To replace the heat sink and processor fan, perform the above steps in reverse order.
Back to Removing and Replacing Parts
Computer.
(applicable on E6410 ATG computer only).