Usb Connector Board - Dell Vostro 1700 Service Manual

8. Remove the palm rest (see
9. Remove the M2.5 x 5-mm screw that secures the CIR board to the base of the computer.
10. Lift the CIR board out of the computer.
NOTICE: Do not disconnect the CIR cable from the system board.
11. Disconnect the CIR cable from the CIR board.
Replacing the CIR Board
CAUTION: Before you begin the following procedure, follow the safety instructions in the Product Information Guide.
1. Connect the CIR cable to the CIR board.
2. Align the screw hole in the CIR board with the screw hole in the base of the computer, and then lower the board into place.
3. Replace the M2.5 x 5-mm screw and secure the CIR board to the base of the computer.
4. Replace the palm rest (see
5. Replace the internal card with Bluetooth wireless technology, if installed (see
6. Replace the display assembly (see
7. Replace the keyboard (see
8. Replace the hinge cover (see
9. Replace the hard drive (see
10. Replace the optical drive (see
USB Connector Board
Removing the USB Connector Board
CAUTION: Before you begin the following procedure, follow the safety instructions in the Product Information Guide.
1. Follow the instructions in Before You
2. Remove the optical drive (see
Removing the Palm Rest).
Replacing the Palm Rest).
Replacing the Display Assembly).
Replacing the Keyboard).
Replacing the Hinge Cover).
Replacing a Hard Drive).
Replacing the Optical Drive).
Begin.
Removing the Optical Drive).
Replacing the Bluetooth Card).