Floppy Drive - Dell OptiPlex 760 Service Manual

8. Locate an unused SATA connector on the system board and attach a data cable to this connector and to the second hard drive.
1 data cable 2
3 power cable
9. Replace the computer cover (see
10. Enter system setup (see System
11. Exit system setup, and reboot the computer.
12. Partition and logically format your drive.
See the documentation for your operating system for instructions.
13. Test the hard drive by running the Dell Diagnostics (see
14. If the drive you just installed is the primary drive, install your operating system on the hard drive.

Floppy Drive

WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the computer cover.
hard drive system board connector
Replacing the Computer Cover).
Setup), and update the SATA port option under the Drives option list.
Dell Diagnostics).