Dell OptiPlex 760 Service Manual page 114

8. Connect the adapter cable to the PS/2 serial port adapter connector (PS2/SERIAL2) on the system board (see
NOTE: See the documentation for the PS/2 serial port adapter for information about the cable connections.
9. Replace the computer cover (see
Removing a PS/2 Serial Port Adapter
1. Follow the procedures in Working on Your
2. Remove the computer cover (see
3. Gently lift the release tab on the card retention latch from the inside to pivot the latch open. Pivot the latch until it snaps into the open position.
4. Disconnect the PS/2 serial-port cable from the system board (see
5. Ease the PS/2 serial-port adapter bracket out of its retention slot.
6. If you are removing the adapter permanently, install a filler bracket in the empty card-slot opening.
NOTE: Installing filler brackets over empty card-slot openings is necessary to maintain FCC certification of the computer. The brackets keep dust
and dirt out of your computer and maintain the airflow that cools your computer.
7. Before you close the card retention mechanism, ensure that:
The tops of all cards and filler brackets are flush with the alignment bar.
l
The notch in the top of the card or filler bracket fits around the alignment guide.
l
8. Secure any remaining card(s) by closing the card retention latch and snapping it into place.
9. Replace the computer cover (see
Back to Contents Page
Replacing the Computer Cover.
Computer.
Removing the Computer Cover).
System Board
Replacing the Computer Cover).
System Board
Components).
Components).