D-Link Ethernet Broadband Router DIR-100 User Manual page 19

Setup Wizard – Configure Russia PPPoE Connection
For PPPoE connections, select the Address Mode Dynamic IP or Static IP, type in the Username and
Password used to identify and verify your account to the ISP. Retype the password again and if necessary,
type a Service Name or domain name. For Static IP address mode, type the IP Address assigned to your
account. Your ISP should provide this IP address along with other account information. An additional set of
IP settings might be required to create a static route to the ISP. Enter the WAN IP settings used to create this
route (as given by the ISP) and click Next to continue.
PPPoE Setting
User Name
Password
Retype Password
Service Name
WAN Physical Settings
DIR-100 Ethernet Broadband Router
Description
The PPPoE user name used to establish the identity of your ISP
account. Typically this is in the form user1234@isp.com.ru - some
users may be allowed to select a personalized user name for their
account.
Enter the password used to verify the identity of your account. Your
ISP may have provided this to you or you might have chosen a
personalized password that is easy to remember. The password is
case-sensitive, so type the characters exactly as given to you.
Retype the password exactly as entered in the previous field.
Enter the Service Name provided by your ISP if necessary
(optional).
Some PPPoE connections use a static route to the ISP. This
requires that an additional set of IP settings be defined for the WAN
port. Configure these settings as instructed by the ISP.
13