Status Display Board; Figure 4-28. Status Display Board Removal - Dell Latitude LM Service Manual

Status Display Board

top assembly
speaker
connector (2)
(screws S7–S9
are 6 mm)
status display
board
6 mm

Figure 4-28. Status Display Board Removal

To remove the status display board, follow these steps:
1. Remove the top assembly.
See "Top Assembly" found earlier in this section.
2. Remove status-display board screws S7, S8, and S9.
3. Disconnect the two speaker connectors and the infrared device connec-
tor from the status display board.
4. Disconnect the status display board connector from the main board.
The connector wire assembly is held in place by a metal hook located on the
I/O bracket.
5. Remove the status display board from the top assembly.
S7
S8
S9
infrared
device
connector
status-
display
board
connector
Removing and Replacing Parts 4-35