Clarion HX-D2 Owner's Manual page 20

Operations Common to Each Mode
Setting the input level for portable
audio (AUX SENS)
This unit is provided with two AUX input lines.
The input level for third-party portable audio
connected to each of these lines can be set.
* The factory default setting is "MID".
1. Press the [ADJ] button.
2. Press the [ ] or [
SENS".
3. Press the [s] button.
4. Press the [ ] or [ ] button to select the input
line.
Each press of the button switches the line as
follows:
AUX1 SENS: Input line 1
AUX2 SENS: Input line 2
5 Press the [ ] button.
6. Press the [ ] or [ ] button to select "HIGH",
"MID" or "LOW".
7. When you select this, press the [
to return to the screen in step 4.
8. Repeat steps 4 to 7 to set the input level of
each input line.
9. Press the [ADJ] button to return to the
previous mode.
Setting the digital output (D-OUT)
Set digital output ON when the digital output
connector is used as the digital output
connector of the built-in CD. There is no output
when "OFF" is set.
∗ This item cannot be set when a CD changer is
connected via the CeNET cable.
* The factory default setting is "OFF".
1. Press the [ADJ] button.
2. Press the [ ] or [
OUT".
3. Press the [ ] or [ ] button to select "ON" or
"OFF".
4. Press the [ADJ] button to return to the
previous mode.
24
HX-D2
] button to select "AUX
] button
] button to select "D-
Setting the anti-theft indicator
(BLINK LED)
This function makes the indicator of Pch6 blink
(red) when ACC is OFF to create a visual anti-
theft effect.
* The factory default setting is "OFF".
1. Press the [ADJ] button.
2. Press the [ ] or [
"BLINK-LED".
3. Press the [ ] or [ ] button to select "ON" or
"OFF".
4. Press the [ADJ] button to return to the
previous mode.
Setting the beep tone during button
operation (BEEP)
A high-pitched beep tone is emitted when you
operate a button. This beep output can be
disabled.
* The factory default setting is "ON".
1. Press the [ADJ] button.
2. Press the [ ] or [
"BEEP".
3. Press the [ ] or [ ] button to select "ON" or
"OFF".
4. Press the [ADJ] button to return to the
previous mode.
] button to select
] button to select