Dell Inspiron 7000 Service Manual page 81

4-46
This section provides the removal procedure for the palmrest assembly.
4-mm screw
washer
speaker wire harness
and grounding strap
palmrest
assembly
connector
for speaker
wire
harness
base
assembly
combo bay
4-mm
screws (6)
battery bay
hard-disk
drive bay
This procedure assumes that you have removed the keyboard, thermal shield,
and display assembly. To remove the palmrest assembly, follow these steps
(see Figure 4-30):
1. Turn the unit over and place it face down.
2. Remove the two 4-mm screws from the top inside of the combo bay.
3. Remove the two 4-mm screws from the top inside of the battery bay.
4. Remove the two 4-mm screws from the top inside of the hard-disk drive
bay.
LED cable
6-mm
screws (4)
LED connector
DC-DC board