Dell Inspiron 7000 Service Manual page 72

This section provides the removal procedure for the display assembly.
6-mm screws (4)
hinges (2)
hinge saddles (2)
This procedure assumes that you have removed the keyboard and thermal
shield. To remove the display assembly from the computer, follow these steps
(see Figure 4-24):
1. Disconnect the LCD wire harness from connector JP3.
Use a dental pick or flat-blade screwdriver to pry up each end of the con-
nector to release it.
2. Close the display.
3. Remove the four 6-mm screws that secure the two hinges.
4. Unlatch the display assembly and lift the assembly off the computer base.
LCD wire
harness
connector
JP3
Removing and Replacing Parts 4-37