Compaq Evo N200 Maintenance And Service Manual page 80

Removal and Replacement Procedures
5. Remove the following screws:
❏
❏
❏
6. Use a 9/64" hex wrench to remove the two bushing guides 4
on each side of the docking connector.
Figure 5-13. Removing the Top Cover Screws (Continued)
5–20
two pewter TM2 × 8 screws 1 that secure the top cover
to the base enclosure (Figure 5-13)
two black TM2 × 4 screws 2 from the rear panel
two 5.0 mm screwlocks 3 on each side of the external
monitor connector
Maintenance and Service Guide