Thread The Needle - Kenmore 385. 17922 Owner's Manual

Prep=' TOp T h read
• Thread the Needle
®
The numbered steps above follow the numbers
on the illustrations.
Dotted lines show places where the thread
loops and then is pulled tight.
Raise the take*up lever to its h_ghest position by turning the hand wheel toward you.
Raise the presser foot lever.
Ptace the spook on the spool pin as shown, with thread coming from the back of the spool
1. Draw thread into thread guide using both hands.
2. While holding thread near spool, draw thread down into the tension area and then around the check
sprin g h older.
3. Firmfy draw thread up and through take-up lever from r_ght to left.
4. Draw thread down and slip it through the thread guide_
5. Thread then is slipped into needle bar thread gu'ide,
6. Thread needle from front to back.
NOTE: Cut the end of the thread with sharp scissors for easier needle threading.:
19