Cisco 40-Gigabit and 100-Gigabit CFP Transceiver Modules Installation Notes page 15

When you are ready to attach the network cable interface, remove the dust plugs and inspect and clean
Step 8
fiber connector end faces, and then immediately attach the network interface cable connectors into the
CFP transceiver optical bores. (See
Note
For complete information on inspecting and cleaning fiber-optic connections, see the white-paper
document at this URL:
http://www.cisco.com/en/US/tech/tk482/tk876/technologies_white_paper09186a0080254eba.shtml
Figure 7
SC connector
Network interface
OL-23946-01
If you are installing a FourX adapter (CVR-CFP-4SFP10G=) (shown in
install 10GBASE-X SFP+ transceivers in the adapter ports. Follow the SFP+ transceiver
installation procedure documented at:
http://www.cisco.com/en/US/docs/interfaces_modules/transceiver_modules/installation/note/7
8_15160.html
Cabling an Optical CFP Transceiver Module with SC Connectors
L I N
K
cable
Cisco 40-Gigabit and 100-Gigabit CFP Transceiver Modules Installation Note
Figure 7and Figure 8.)
1
2
L I N
K
A C
T I
V E
Installing the CFP Transceiver
Figure 3), you must
15