Cisco 40-Gigabit and 100-Gigabit CFP Transceiver Modules Installation Notes page 17

40-gigabit and 100-gigabit cfp transceiver modules
Table of Contents

Advertisement

If you need to remove a CFP transceiver, follow these steps:
Disconnect the network fiber-optic cable from the CFP transceiver connectors. Immediately reinstall the
Step 1
dust plugs in the CFP transceiver optical bores.
Loosen the two captive installation screws that secure the CFP to the networking module.
Step 2
Slide the CFP transceiver out of the module socket. (See
Step 3
transceiver in antistatic protective packaging.
Figure 9
Captive installation
Optical bore
dust plugs
OL-23946-01
Removing a CFP Transceiver Module
screws
Cisco 40-Gigabit and 100-Gigabit CFP Transceiver Modules Installation Note
Removing the CFP Transceiver
Figure
9.) Immediately place the CFP
17

Advertisement

Table of Contents
loading

Table of Contents