2, Assembly
of the Upper & Lower
Channels,
to Cabinet.
(All Models)
•
"L"Shaped Top Channel: Install
the "L"shaped
channel to the top of tile cabinet as shown [n Fig.
8 using four (4) 114" screws.
•
"U" Shaped Bottom CItannel: Install Ihe "U"
shaped channel io the bottom of the cabinel as
shown in Fig. B using four (4) 1/4" screws
NOTE: Some models may already have the
bottom channel factory Installed.
3, Assembly
of the Side Curtains
to Cabinet.
(All Models)
•
Slide the shutters inlo Ihe top and bottom
channels as shown in Fig. 9. The shutters are
idenlilled (on frame) as taft & right
Attach Ihe
shutlers to Ihe cabinet using four 1/4" screws on
each side.
4, Installation
of Mounting
Brackets
and
First Sealing
Strtp (All Models)
SPECIAL NOTE: Windows come in a variety of
different designs and styles
Theralore, {t may be
necessary to modify or improvise on your
particular inelallation.
A.
Attach the bracket assembly
to Ihe 90 ° angle
support brackets
(Fig 16) using four 1 1/2" x
1/4" bolts. (two bolts per brackel)
Secure with the four 1/4" lock washers and four
1/4" nuts. DO NOT immediately tighten these
bolts as it may be necessary to adjust lhe depth
of the bracket assembly, dependin£ on the
deplh of your window sill See Fig's t8 & 19
Test the brackel assembly in lhe window before
installing, if satisfied, tighlen all bolts
lnslall the
two levelling screws into the 90 ° support
brackets See Fig. 16 li the levelling screws a_e
distanced too (ar away from the waTIto provide
adequate stability, it may be necessary to shim
this area with a solid piece oI wood
See Fig. !9.
B Measure the length of the inside sill and find the
center as shown In Fig. 17.
Models; DACFO24DE: Measure 807 !" on each
side of center and mark Ihese points.Align the V-
slot on the bracket with each corresponding
markand
mount the brackets
to tile sil[ using
two 314" screws & tWO flat washers
pe_
bracket
Brackets should be perpendicular to the inside
window sill, with step (U) bracket lighl against Ihe sill
See Fig, f8.,
C. For proper condensation run-off it wil_ be
necessary to adjusl the angle/pitch ot the window
brackets. This is accomplished by adjusting the
distance of Ihe leveling screw on the ouler wall,
The maximum anglelpitch should nol exceed
more than 3/16", See Ffg_ 18
/
/t
\
t/4" Semw
'L" Shaped
Channel
Channels
"U"Shaped
"U" ShapedChannel
Channel
Position
(smaller
spacetoIrenl)
Fig.8
Shut.terFrame
Shu!lers
Fig. 9
As_embr_
ao1_e
t I //""
__ °° An01_
. II.//
_uppotl
Brackets
Levelling
Screws
--.-_.
Fig, 16
I H
L
Fig, 1 7