1,
Preparation to Remove the Air Conditioner
SIIde_Out Chassis (Aft Models)
•
Position the air condilioner in the normal
(upright) posil_on.
-
Remove the air fitter by grasping the tiIler handle
(on front grill) and sliding il lo the right, Ftgo 2
•
Remove the phillips screw (behind fitter)
securing the grill Iront to the chassis (Fig. 4)
-
Remove the phillips screws located on the (lower
lefVright) edge ei front grill (Flg.3)
•
To remove the front gr_!l, grasp ihe lower front
comer of lhe grill, pulling (gently) outward and
upward, (Fig 5)
Repeat lhts slop on the 3 remaining corners,.
•
Before the front grill can be completely removed
from the cabinet, it will be necassary to
disconnect Ihe (msletlemate) electricaf wire
harness located direclly behind the lront grill.
(Fig 5a)
•
Remove the two phillips screws (lower left!right
side of cabinet) securing the slide-oul_chassls to
the cabinet, Figo7
NOTE: These screws must be reinstalled
upon completion of the window Installation°
(to secure slide-out-chassls)
NOTE: Some modets may be inclusive of an
additional (sfide-out chassis) retaining bracket and
screw located at the front of the chassis. This
bracket and screw must also be removed before
attempting Io remove Ihe slide-out chassis. Fig° 6
NOTE: This bracket and screw does not have to
be reinstalled
upon completion of the window
Installation_
Grasp the pull handle at the front of the slide-out-
chassis and carefully slide the air conditioner out
of the cabinet (Fig.6)
Please seek assistance tor Ihis procedure_
i..............
l"
Fig,1
FRO_
P_EL
Rgo 3
!f/'J
Fig.4
Ftg_5-
///
Fig.5.
J
Ft
Fig. 7
/j