Preset Operating Modes; Pin Assignment D-Sub (15-Pin) - Fujitsu Siemens Computers 19P2 Operating Manual

Preset operating modes

The picture position and size have been set to optimum values at the factory for the
i
operating modes listed above. Depending on the screen controller used, it may be
necessary to adjust the display position and size. In this case, you can change and save
the settings (see
Horizontal frequency
31.5 kHz 0.5 kHz
31.5 kHz 0.5 kHz
50,6 kHz 0.5 kHz
53.7 kHz 0.5 kHz
63.0 kHz 0.5 kHz
68.7 kHz 0.5 kHz
80.8 kHz 0.5 kHz
91.2 kHz 0.5 kHz
93.1 kHz 0.5 kHz
For ergonomic reasons we recommend a refresh rate of at least 75 Hz and a maximum resolution of
1024 x 1280 pixels.

Pin assignment D-SUB (15-pin)

Pin
1 Red video input
2 Green video input / Sync. on green
3 Blue video input
4 Monitor ground
5
6 Red video ground
7 Green video ground
8 Blue video ground
A26361-K713-Z100-1-5E19
"Operation of the
100 Hz
100 Hz
100 Hz
100 Hz
10
Meaning
DDC Return
monitor").
Refresh rate
60 Hz 2 Hz
70 Hz 2 Hz
2 Hz
85 Hz 2 Hz
2 Hz
85 Hz 2 Hz
2 Hz
85 Hz 2 Hz
2 Hz
1
5
11
15
Pin
9
10
11
12
13
14
15
Colour monitor 19P2
Screen resolution
640 x 480
720 x 400
640 x 480
800 x 600
800 x 600
1024 x 768
1024 x 768
1280 x 1024
1152 x 864
6
Meaning
5 V for DDC
Logic ground
Monitor ground
DDC data (SDA)
H. sync (H/V comp. Sync.)
V. sync
DDC Clock
(SCL)
English - 19