Advertisement
TO FIND BY NAME
1.
2.
3.
4.
5.
6.
RC-205/210/220
Remote Control Owner's Manual
Press the FIND key (F5).
The DigiCart screen will display:
FIND (Blinking Cursor)
HH:MM:SS
Note: The information on the bottom line pertains to
the current Selection.
Type in the Name for the Cut or Stack you wish to locate.
Note:
You do not have to enter the complete Name of the Cut or
Stack. You can FIND BY NAME by typing in only as much of
the Name as makes the Cut or Stack Name . For example: If
there is a cut Named BOSTON, just type in "BOS".
You can also use the Find By Name function for Cuts whose
Names begin with a number.
Press ENTER.
DigiCart will instantly cue up to the first Cut or Stack that
matches the Name you entered.
Note:
The FIND BY LABEL function is progressive, starting at
Directory "0" on the Bernoulli disk and going through to
Directory "9" on the internal hard disk.
The Name-matching function follows a logical sequence,
beginning with the "0" Directory on the "0" Drive. The FIND
function searches through this Directory first for any matches,
then it search through the "1" Directory on the "0" Drive, and
so on. If it does not find a match on the "0" Drive, it starts
searching in the "0" Directory for the "1" Drive.
Once you have found the first match, you can use the FIND
function again for the same name, and DigiCart will FIND the
next match in this logical sequence of Drives and Directories.
Press PLAY to Play the Cut or enter it into a Stack (see
Chapter 4 of your DigiCart Owner's Manual).
48K AC-2
Second Edition
March 1997
Page 5
Advertisement
