Using Ac Power (Dc In Power); Turning The Power On/Off; Setting The Clock - Sony PMW-50 Operating Instructions Manual

Portable memory recorder
Hide thumbs Also See for PMW-50:
Table of Contents

Advertisement

Using AC Power (DC IN Power)

Connection example: when connecting BC-U1
1
Connect the DC power output cable of
the BC-U1 to the DC IN connector of
the recorder.
2
Connect the power cord of the BC-U1 to
an AC power source.
3
Set the mode switch of the BC-U1 to the
DC OUT position.

Turning the Power On/Off

To turn on the power supply, press the power
button (page 6). The power supply lamp lights up.
To turn off the power supply, press the power
button again.
Notes
• This recorder uses a little standby power even when the
power button is set to OFF. Remove the battery pack if
the recorder will not be used for a prolonged period.
• When removing the battery pack or the DC IN power,
be sure to first set the power button to the OFF
position. Removing the battery pack or the DC IN
power while the recorder is ON may cause damage to
the recorder or the SxS memory card.

Setting the Clock

When you turn the recorder on for the first time
after purchasing or replacing the backup battery
(page 66), the Initial Setting display appears on
the LCD monitor.
Time Zone
The value shows the time difference from UTC
(Coordinated Universal Time).
Change the setting if needed.
Setting the time and date
Move the cursor, then press the SEL/SET button
to set each menu item. When you press the SEL/
SET button when the cursor is on "Finish," the
Initial Setting display disappears, and the clock
setting is completed.
After the Initial Setting display disappears, "Time
Zone" (page 46) and "Clock Set" (page 47) in the
OTHERS menu can be used to set "Time Zone"
and "Date/Time."
Notes
• If the clock setting is cleared because of exhaustion of
the backup battery while no operation power was being
supplied (no battery pack and no DC IN connection),
the Initial Setting display will be displayed when you
turn the recorder on at the next opportunity.
• While the Initial Setting display is shown, no other
operation except turning the power off is permitted
until you finish the setting for this display.
Setting the Clock
11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents