Playing Clips In Repeat Mode; Monitoring Audio; Cueing Up - Sony PMW-50 Operating Instructions Manual

To select a clip for partial playback, attach an OK
flag or OK mark to the clip on the thumbnail
screen.
Playing between In-point and Out-point
Select "PARTIAL PLAYBACK" from the clip
operation menus.
Playback starts from the first clip in the OK-Clip
thumbnail screen.
When playback of the first clip ends, playback
continues with the next clip that has an attached
OK flag or OK mark.
If shot mark 1 only is specified, the clip plays
from shot mark 1 until the end of the clip. If shot
mark 2 only is specified, the clip plays from the
start of the clip up to shot mark 2.
Note
When playing between In-point and Out-point, the signal
cannot be output on i.LINK (DVCAM/HDV).
Trim: Adjusting the In-point and Out-
point
Trimming provides fine control of the playback
start point and stop point.
1
Display the SHOT MARK screen (page
36).
2
Select the shot mark point you want to
trim, then select "TRIM SHOT
MARK1/2" in the clip operation menus.
A still image for the selected frame is
displayed.
3
Use fast-forward/reverse, play/pause,
or slow-motion play (left/right buttons)
to move to the frame for which you want
to set the shot mark.
4
Press the SEL/SET button.
The shot markselected in step 3 is set at the
current point, and the display returns to the
OK-Clip thumbnail screen.

Playing Clips in Repeat Mode

1
Select the thumbnail for the clip you
want to play on the thumbnail screen.
30 Playing Clips
2
Select "CLIP REPEAT" in the clip
operation menus.
The selected clip starts playing, loops back to
the start of the clip when it reaches the end,
and continues playing.
To stop repeat play
Press the STOP/EE button or the THUMBNAIL
button.

Monitoring Audio

In Normal playback mode, you can monitor the
recorded audio signals through the built-in
speaker (page 6) or connected headphones.
With the headphones connected to the headphone
connector (page 6), the built-in speaker is turned
off.
Press the VOLUME buttons (page 6) to adjust the
sound volume.
You can select audio channel(s) to be monitored
with "Audio Output" (page 42) in the AUDIO
SET menu.

Cueing Up

To start playback from the top of the first clip
Press the PREV button and F REV button
simultaneously.
To start playback from the top of the last clip
Press the F FWD button and NEXT button
simultaneously.