Sony PMW-50 Operating Instructions Manual page 16

Item Setting
Password Password for log-in (factory default
setting: model name "pmw-50")
a) IP address determined by the DHCP server.
When you have changed a setting
Set the Set item to [Execute]. When a
confirmation message appears, select "Execute"
and press the SEL/SET button.
To make a connection in ad hoc mode
1
Refer to "Settings on the Computer"
under "Making a Wi-Fi Connection to
Your Computer (Ad hoc Mode)" in the
Operating Instructions supplied with
the CBK-WA01 to make settings on the
computer.
2
Start a connection on the computer.
3
Set OTHERS >Wi-Fi >Wi-Fi to
[Enable] in the setup menu.
4
Set OTHERS >Wi-Fi >Scan Networks
to [Execute] and press the SEL/SET
button.
When networks are detected, the
NETWORK SCAN list appears.
5
Select a network and press the SEL/
SET button.
6
Confirm that the settings for the Wi-Fi
item conform to the network setting on
the computer.
SSID (network name): Selected network
name
Network Type (connection mode): Adhoc
CH (channel): 1
Authentication (network authentication):
Depending the settings on the computer,
Open, Shared or WPA
Encryption (data encryption): Depending
the settings on the computer, Disable, WEP,
TKIP or AES
WEP Key Index (key index): 1 when
Encryption is set to [WEP]
Input Select (key input format): Depending
the network key (or security key), ASCII5,
ASCII13, HEX10 or HEX26 when
16 Using a Wi-Fi Adapter
Encryption is set to [WEP], ASCII8-63 or
HEX64 Encryption is set to [TKIP] or [AES]
7
Set the Key item to the network key (or
security key) set on the computer and
press the SEL/SET button.
8
Set the Set item to [Execute] and press
the SEL/SET button.
If the connection to the computer is
complete, then the message changes to "Wi-
Fi Setting OK".
Black squares appear in the Wi-Fi Status
column to show the connection status. (The
number of squares shows the level of
connection status.) In the Wireless Mode
column, the IEEE802.11 standard of the
established connection appears (802.11b,
802.11g or 802.11n).
Tip
It is also possible to make a connection by
accessing a network connection started on the
recorder from the computer.
To terminate the connection
Terminate the connection on the computer.
To revert to the default settings (reset)
If you have trouble making a connection, or you
want to start over, you can reset your Wi-Fi
connection settings to their defaults.
Set OTHERS >Network >Net Config Reset in the
setup menu to "Execute" and press the SEL/SET
button.
If the reset is executed, the message "Net Config
Reset Done" appears.
The recorder attempts to connect to the network
using a MAC address as the SSID.
To make a connection in infrastructure
mode
Setting up the wireless LAN access point
The following settings are required.
• Network ID (SSID)
• Encryption method
• Network key (Key)
To find and connect to a wireless LAN from the
recorder
Perform the same procedure in "To make a
connection in ad hoc mode" (page 16) excluding
the following.
• Do not perform steps 1 and 2.