Sony PDW-U1 Operation Manual page 2

User manual (pdw-u1 professional disc drive unit operation manual for firmware version 2.10 (ed. 2 rev. 1))
Hide thumbs Also See for PDW-U1:
Table of Contents

Advertisement

WARNING
To reduce the risk of fire or electric shock,
do not expose this apparatus to rain or
moisture.
To avoid electrical shock, do not open the
cabinet. Refer servicing to qualified
personnel only.
WARNING
When installing the unit, incorporate a
readily accessible disconnect device in the
fixed wiring, or connect the power plug to
an easily accessible socket-outlet near the
unit. If a fault should occur during
operation of the unit, operate the disconnect
device to switch the power supply off, or
disconnect the power plug.
WARNING: THIS WARNING IS
APPLICABLE FOR USA ONLY.
If used in USA, use the UL LISTED power
cord specified below.
DO NOT USE ANY OTHER POWER
CORD.
Plug Cap Parallel blade
(NEMA 1-15P Configuration)
Cord
Type NISPT-2 or SPT-2, two
16 or 18 AWG wires
Length
Minimum 1.5 m (4 ft. 11in.),
Less than 2.0 m (7 ft.)
Rating
Minimum 7A, 125V
Using this unit at a voltage other than 120V
may require the use of a different line cord
or attachment plug, or both. To reduce the
risk of fire or electric shock, refer servicing
to qualified service personnel.
WARNING: THIS WARNING IS
APPLICABLE FOR OTHER
COUNTRIES.
1. Use the approved Power Cord (2-core
mains lead) / Appliance Connector / Plug
that conforms to the safety regulations of
each country if applicable.
2. Use the Power Cord (2-core mains lead) /
Appliance Connector / Plug conforming
to the proper ratings (Voltage, Ampere).
2
If you have questions on the use of the
above Power Cord / Appliance Connector /
Plug, please consult a qualified service
personnel.
The PDW-U1 is classified as a CLASS 1
LASER PRODUCT.
Laser diode properties
Wavelength: 400 to 410 nm
Emission duration: Continuous
Laser output power: 135 mW (max. of
pulse peak), 65 mW (max. of CW)
Tekniska data för laserdiod
Våglängd: 400 till 410 nm
Emissionslängd: Kontinuerlig
Laseruteffekt: 135 mW (max. för
pulstopp), 65 mW (max. för kontinuerlig
våg)
Spesifikasjoner laserdiode
Bølgelengde: 400 til 410 nm
Strålingens varighet: Kontinuerlig
Laserens effekt: 135 mW (maks
stråletoppunkt), 65 mW (maks ved
kontinuerlig stråling)
Laserdiodin ominaisuudet
Aallon pituus: 400 - 410 nm
Välityksen kesto: Jatkuva
Laserlähdön teho: 135 mW (sykehuipun
maks.), 65 mW (jatkuvan aallon maks.)

Advertisement

Table of Contents
loading

Table of Contents