Ice Maker Operation; Water Dispenser (Dispenser Models) - Sub-Zero IC-24FI Use & Care Manual

OPERATION

Ice Maker Operation

To initiate ice production, touch the
options screen. A single highlighted cube indicates the ice
maker is active. Three highlighted cubes indicate the max
ice feature is active. Max ice increases ice production up to
30% for a 24-hour period. During that period, some com-
ponents may run at a higher speed resulting in a unique
audible tone. This is typical and will revert back after 24
hours or when the ice container is full. To deactivate the ice
maker, touch until no cubes are highlighted. After initial
start-up, discard the first few batches of ice. The ice may
contain impurities from new plumbing connections.
If ice is not used regularly it may fuse together. To avoid,
discard ice and allow ice maker to replenish.
The ice maker must be turned off by touching
ice storage container is removed. The unit is equipped with
a 3-minute delay after the ice container has been removed,
to ensure cubes are not ejected before the ice maker can be
deactivated or ice container is reinstalled.
Sabbath
This appliance is certified by Star-K to meet strict religious
regulations in conjunction with specific instructions found
on www.star-k.org.
For Sabbath mode, from the settings screen, touch
follow instructions on the control panel.
|
12 Sub-Zero Customer Care 800.222.7820
Water Dispenser
indicator on the The water dispenser is located inside the refrigerator on
the left wall. Press a glass against the dispenser to activate
water flow. Water flow will stop when the glass is pulled
away. Refer to the illustration below.
The chilled water reservoir tank holds approximately 40 oz
(1.2 L)
water to refrigerator temperature during the original fill and
after a large amount of water is dispensed.
To fill the tank, press a glass against the dispenser until
water begins to flow. A safety feature was incorporated into
the dispenser to limit continuous water flow to 60 seconds.
If water does not dispense within 60 seconds, remove the
glass, then reapply to the dispenser until water begins to
when the flow. Once the tank is full, discard the first few glasses
of water. It may contain impurities from new plumbing
connections.
and
Water dispenser.
of filtered water. It may take several hours to chill the
WATER DISPENSER