Sony XC505 Technical Manual page 22

3D-NR Setting
Command
3DNR-MODE
Name
Parameter 1 Filter selection: 0 to 3
0: 3D-NR disabled
1: Mild 3D-NR
2: Moderate 3D-NR
3: Strong 3D-NR
Default is 0
Conditions None
Process Sets the strength of 3D-NR noise
suppression. Higher noise suppression
corresponds to lower dynamic resolution as
the afterimage becomes more visible.
Pedestal Setting
Command
PEDESTAL
Name
Parameter 1 0 to 22 (corresponds to NTSC: 0 to 10 [IRE],
and PAL: PAL 0 to 70 [mV])
Default is 11 (NTSC: 5 [IRE], and PAL: 35
[mV])
Conditions None
Process Adjusts the pedestal.
Does not affect gamma-curve compensation.
Gamma Table Setting
Command
GAMMA-MODE
Name
Parameter 1 Gamma curve: 0 to 2
0: γ = 1.0
1: γ = 0.45(γ = 1/2.2)
2: γ = 0.6(γ = 1/1.6)
Default is 1
Conditions None
Process Specifies the gamma curve of the YC signal
(the specified C is used regardless of the
GAMMA-MODE setting.)
Polarity (Nega/Posi) Setting
Command
NEGAPOSI
Name
Parameter 1 Polarity: 0 to 1
0: Positive
1: Negative
Default is 0
Conditions None
Process Inverts the YC signal after gamma curve
compensation.
22
Camera Control Commands
High Brightness Clipping Setting
Command
WHITECLIP
Name
Parameter 1 Brightness signal clipping level: 0 to 63
0: Minimum to
1: Maximum (no clipping)
Default is 63
Conditions None
Process Clips brightness exceeding the specified level
in the final output of the Y signal.
Use this function to avoid image whiteout.
WPC (White Pixel Compensation)
Enable/Disable White Point Detection
Compensation
Command
WPC-MODE
Name
Parameter 1 White point detection compensation enable/
disable: 0 to 1
0: OFF
1: ON
Default is 1
Conditions None
Process Enables or disables auto detection of white
point compensation.
Execute Auto White Point Detection
Command
WPC-EXE
Name
Parameter None
Conditions None
Process Starts auto white point detection processing.
Execute with the lens covered, such as by a
lens cap.
White Point Compensation Marker Setting
Command
WPC-DISP
Name
Parameter 1 Marker display/non-display: 0 to 1
0: OFF
1: ON
Default is 0
Conditions Display is only possible when WPC-MODE is
1.
Process The marker indicates the white point location
on the object of compensation.