Formatting The Phu-60K/120K/120R - Sony PMW-350K Supplement Manual

3
Fit the bottom plate (spring type) into
the auxiliary shoe.
Insert the bottom plate from the end where
the slits for the screw holes of the auxiliary
shoe are not open.
If you secure the auxiliary shoe in the
direction opposite that shown in the above
figure with the slit open end forward, insert
the bottom plate from the direction opposite
to that shown in the figure.
4
Attach the shoe adapter (supplied with
the PHU-60K/120K/120R) to the hard
disk unit, mount the unit to the
auxiliary shoe on the camcorder, and
secure it with the lock lever of the shoe
adapter.
For details, refer to the Operating Instructions
of the PHU-60K/120K/120R.
To connect the PHU connection cable
1
Open the cover of the card slot block
and insert the PHU connection cable
into a slot.
4 Using a PHU-60K/120K/120R
Bottom plate
2
Turn on the PHU-60K/120K/120R.
The POWER indicator of the PHU-60K/
120K/120R lights in green.
Subsequently, the ACCESS lamp of the
camcorder lights in orange then changes to
green once the unit is ready for use.
Note
Bundle the cable so that it will not accidentally become
entangled with nearby objects.
To disconnect the PHU connection cable
Operate in the same manner as when you remove
an SxS memory card from the slot.
Formatting the PHU-60K/120K/
120R
To format a PHU-60K/120K/120R when
you connect it
When you connect an unformatted PHU-60K/
120K/120R, or connect a PHU-60K/120K/120R
that is formatted to different specifications, or
power the camcorder on with an unformatted
PHU-60K/120K/120R connected, or exit mass
storage mode with an unformatted PHU-60K/
120K/120R connected, a message appears on the
viewfinder screen asking if you want to format
the device.
If the message appears, turn the MENU knob to
select [Execute], and then press the knob.
Notes
• The format confirmation message does not appear if
you are currently setting other information.
• The format confirmation message may disappear if the
camcorder needs to display other information. It
reappears after the other information has been set.
Insert so that the cable extends upward.