Block Diagram - Vox Tonelab LE Owner's Manual

7. CANYON
................................Mono In/Stereo Out 1
This models the reverberation of a canyon.
8. ROOM
....................................Mono In/Stereo Out 1
This models the reverberation of a typical room,
with numerous early reflections.
9. STUDIO
..................................Mono In/Stereo Out 1
This models the reverberation of a large room.
10. HALL
.....................................Mono In/Stereo Out 1
This models the reverberation of a concert hall
with numerous echoes.

BLOCK DIAGRAM

Mono In / Mono Out 1 Mono In / Mono Out 2
Mono In / Stereo Out 2
Mono In / Stereo Out 1
Stereo In / Stereo Out 1 Stereo In / Stereo Out 2
11. ARENA
.................................Mono In/Stereo Out 1
This models an arena with smooth and dense
reverberation.
[1] "TIME"................................................ 1.0...10.0
* Sets the reverb time, which will differ depend-
ing on the reverb type.
[2] "LO DAMP" ........................................ 1.0...10.0
* Adjusts the attenuation of the low-frequency
range.
[3] "HI DAMP".......................................... 1.0...10.0
* Adjusts the attenuation of the high-frequency
range.
[4] "PRE DLY"...................................... 1.0...70[ms]
Sets the initial delay before the reverberation
begins. By adjusting this setting you can clarify
the definition of the original sound.
[6] "MIX" .................................................. 1.0...10.0
* Adjusts the mix amount of the reverb.
Mono In / Mono Out 3
Stereo In / Stereo Out 3
45