Replacing The Palm Rest - Dell 1525 - Inspiron - Pentium Dual Core 1.86 GHz Service Manual

1 screws (2) 2 palm rest
3 touch pad connector 4 device status lights LED connector
5 display hinge screw
11. Moving from left to right, carefully lift the palm rest along the rear edge, near the hinge brackets, then gently lift the palm rest to remove it from the
computer.

Replacing the Palm Rest

CAUTION: Before you begin the following procedure, follow the safety instructions in the Product Information Guide.
1. Align the palm rest with the base of the computer and gently snap it into place.
2. Connect the touch pad connector and the device status lights LED connector to the system board.
3. Replace the two screws on the top of the palm rest.
4. Turn the computer over and replace the nine screws on the bottom of the computer to secure the palm rest.
Back to Contents Page