Video Graphics Board - Dell Precision M40 Service Manual

NOTICE: Proper seating of the microprocessor module does not require force.
NOTICE: A microprocessor module that is not properly seated can result in an intermittent connection and subsequent failures.
1. Align the pin-1 triangle on the microprocessor toward the pin-1 triangle in the socket, insert the microprocessor into the socket, and move it around
slightly until you feel it settle into the socket.
When the microprocessor module is correctly seated, all four corners are aligned to the same height. If one or more corners of the module are higher
than the others, the module is not seated correctly.
NOTICE: Hold the microprocessor down while turning the cam lock screw to prevent intermittent contact between the cam lock screw and
microprocessor (see "Microprocessor Cam Lock
2. Tighten the cam lock screw.
NOTICE: Do not over- or under-tighten the screw. Tighten it until the screw indicator points to the "closed" or "locked" indicator on the socket.
3. Replace the microprocessor thermal cooling assembly.
Closing the Microprocessor Retaining Clip
4. While pressing lightly down on the center of the retaining clip, insert a nonmarring screwdriver into the latch mechanism and pivot the top of the
screwdriver away from the clip to close the latch.

Video Graphics Board

NOTICE: Disconnect the computer and attached devices from electrical outlets and remove any installed batteries.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by periodically touching unpainted metal on the computer.
Video Graphics Board
Screw").