Fujitsu Solaris PCI GigabitEthernet 3.0 User Manual page 67

Appendix A Messages
No
3 Illegal value for [ParameterName].
4 soft state alloc failed.
Allocation of descriptor memory
5
failed
6 fail to ddi_dma_bind_handle
7 fail to FragCount
8 Could not allocate DMA handle
9 Could not bind descriptor memory
10 Multiple fragments in descriptor area
11 fjgiallocthings failed
12 pci_config_setup_failed
60
Message Cause
[E]
Master: Communicating as
Master
Slave: Communicating as
Slave
An error was found with a
parameter defined in the
fjgi.conf file.
Driver internal resources
cannot be obtained.
The driver could not allocate
internal resources for DMA.
The driver could not allocate
DMA resources.
A error was found in message
fragmentation.
The driver could not allocate
DMA resources.
The driver could not allocate
DMA resources.
A error was found in message
fragmentation.
The driver could not allocate
DMA resources.
The driver could not allocate
sufficient PCI configuration
space.
Workaround
Check whether the value
is set correctly in the
file.
Installed physical
memory may be
insufficient. If this is
not the cause, report
this error to your
service provider.
Installed physical
memory may be
insufficient. If this is
not the cause, report
this error to your
service provider.
Re-activate the
interface. If this
message is still
displayed, report to
your service provider.
Installed physical
memory may be
insufficient. If this is
not the cause, report
this error to your
service provider.
Re-activate the
interface. If this
message is still
displayed, report to
your service provider.
Installed physical
memory may be
insufficient. If this is
not the cause, report
this error to your
service provider.
Installed physical
memory may be
insufficient or hardware
has failed. Report this
error to your service
provider.