Part Names And Features Of Hardware - Fujitsu Solaris PCI GigabitEthernet 3.0 User Manual

Chapter 1 Product Outline
connection is not supported.
● When using 1000Mbps transfer rate with PW008GE5, PW0G8GE2, PRIMEPOWER250/450
secondary LAN port, SE0X7GD1X, PW008QG1 and SE0X7GQ1X, only Auto-Negotiation=On can
be used.

1.2.2 Part Names and Features of Hardware

Figure 1.1 to 1.8 shows the appearance of the FUJITSU PCI GigabitEthernet adapters. The
part names and features are listed as follows.
Connection:
PW008GE4, PW0G8GE1 and SE0X7GD2X allow optical fibre cable connection, PW008GE5, PW0G8GE2,
PRIMEPOWER250/450 secondary LAN port, SE0X7GD1X, PW008QG1 and SE0X7GQ1X allow twisted pair
cable connection. See the section "Chapter 2 Installing FUJITSU PCI GigabitEthernet Card"
for detailed information.
LEDs:
PW008GE4 (1000BASE-SX) has two LEDs(1000M LED, ACT LED) indicating transmission rate and
activity. PW0G8GE1 and SE0X7GD2X (1000BASE-SX) has two LEDs(LINK LED, ACT LED) indicating
transmission rate and activity. PW008GE5 and PW0G8GE2 (10/100/1000BASE-T) have four
LEDs(1000M LED, 100M LED, 10M LED, ACT LED) indicating 1000Mbps, 100Mbps, 10Mbps, and
activity. SE0X7GD1X (10/100/1000BASE-T) have three LEDs(1000M LED, 100M LED, LINK/ACT LED)
indicating 1000Mbps, 100Mbps, and activity. PW008QG1 and SE0X7GQ1X (10/100/1000BASE-T)
has two LEDs(LINK LED, ACT LED) indicating transmission rate and activity. See "Appendix
B On-Board Diagnostics" for detailed information.
4