Command Messages - Fujitsu Solaris PCI GigabitEthernet 3.0 User Manual

Message
fjgi_device_check: fjgi_hw_init
failed !
pci_config_setup_failed
Autonegotiation_failed
A.2

Command Messages

Messages from the /etc/opt/FJSVla/bin/fjla command are listed in TableA.2 ("XX" indicates
user input value.)
No
fjla init: The number of
members (including
1
aggregator-interface) is max
8.
2 FJ LinkAggregation now start.
fjla init: "XX" does not
3
support FJ LinkAggregation.
fjla init: "XX" vlan
4 interface cannot define FJ
LinkAggregation.
fjla init: A member interface
5
has already been plumbed.
fjla init: "XX" is not plumbed
6
interface.
fjla init: Input member is
7
duplicated.
An error occurred during
initialization of the adapter.
The driver could not allocate
sufficient PCI configuration
space.
The Auto-Negotiation of
1000BASE-SX failed.
Table A.2 Command Message
Message
More than 8 interfaces
were specified for an
aggregation group.
LinkAggregation has been
started normally.
The interface "XX" doesn't
support the
LinkAggregation feature.
VLAN interface "XX" can
not be used for the
LinkAggregation feature.
The interface specified as
a LinkAggregation group
member is already plumbed.
"XX" interface specified
as an
aggregator-interface is
not activated.
The instance number is
duplicated in the
specified member list
(including
aggregator-interface).
Meaning
There is a possibility of
hardware abnormalities.
Please replace the
adapter.
There is a possibility of
the resource shortage or
hardware abnormalities.
Please check the memory
usage and adapter
installation status.
Check the transmission
mode and the adapter
hardware.
Cause
Specify less than or equal
to 8 interfaces (including
aggregator-interface).
There is no problem.
If the interface is fjgi,
check the patch level of
the driver.
By setting up the physical
interface to use
LinkAggregation, the VLAN
interfaces associated with
the physical interface
also use LinkAggregation.
Unplumb all member
interfaces except the
aggregator-interface.
The interface specified as
an aggregator-interface
must be activated
(viewable by ifconfig -a).
Do not specify the same
instance number in the
LinkAggregation member
list (including
aggregator-interface).
A.2 Command Messages
Workaround
Workaround
63