Charging Battery Pack - Bosch 34612 - 12 Volt Compact Tough Drill Driver Operating Instructions Manual

CHARGING BATTERY PACK (30
INDICATORS, SYMBOLS AND MEANING
If the indicator lights are "OFF", the charger
is not receiving power from power supply
outlet.
],the 0reen in0i tor i0,t is
,, .,,. "ON", the charger is plugged in
but the battery pack is not
inserted, or the battery pack is fully charged
and is being trickle charged.
[.)_i" _] If the green indicator lig htis
"BLINKING", the battery pack is
• ;' being fast-charged. Fast-
charging will automatically stop when the
battery pack is fully charged.
MINUTE SINGLE BAY-BC130)
[,+,,. _i1=j If the red indicatorlight is "ON",
,, ,,. the battery pack is too hot or
cold for fast-charging. The
charger will switch to trickle charge, until a
suitable temperature is reached, at which
time the charger will switch automatically to
fast-charging.
[)_i _J If the red indicat°r light is
.... BLINKING", the battery pack
cannot accept a charge or the
contacts of the charger or battery pack are
contaminated. Clean the contacts of the
charger or battery pack only as directed in
these operating instructions or those
supplied with your tool or battery pack.
Plug charger cord into your standard power
outlet. Before inserting battery pack, remove
protective cap, then insert battery pack into
charger (Fig. 7).
The charger's green indicator light will begin to
"BLINK". This indicates that the battery is
receiving a fast charge. Fast-charging will
automatically stop when the battery pack is
fully charged.
When the indicator light stops "BLINKING"
(and becomes a steady green light) fast
charging is complete.
The battery pack may be used even though
the light may still be blinking. The light may
require more time to stop blinking depending
on temperature. When you begin the charging
process of the battery pack, a steady red light
could also mean the battery pack is too hot or
too cold.
Ila[_ikJ
PACK
CHARGER
The purpose of the green light is to indicate
that the battery pack is fast-charging. It does
not indicate the exact )oint of full charge. The
light will stop blinking in less time if the battery
pack was not completely discharged.
When charging several batteries in sequence,
the charge time may slightly increase.
When the battery pack is fully charged,
unplug the charger (unless you're charging
another battery pack) and slip the battery
pack back into the tool.
To prevent fire or injury
when batteries are not in
tool or charger, always place protective cap
onto end of battery pack. Protective cap,
guards against terminal shorting.
BATTERY PACK
RELEASE TABS
PROTECTIVE
CAP
RED
GREEN
-12-