Bosch 34612 - 12 Volt Compact Tough Drill Driver Operating Instructions Manual page 13

CHARGING BATTERY PACK
INDICATORS, SYMBOLS AND MEANING
If the indicator lights are "OFF", the charger is
not receiving power from power supply outlet.
, !., j_= ] If the red indicator light is "ON",
[_,_ the battery pack is too hot or
J
cold for fast-charging. The
charger will switch to trickle charge, until a
suitable temperature is reached, at which time
the charger will switch automatically to fast-
charging.
ifthe red indicator light is
.... BLINKING", the battery pack
cannot accept a charge or the
contacts of the charger or battery pack are
(30 MINUTE DUAL BAY-BC230)
contaminated. Clean the contacts of the
charger or battery pack only as directed in
these operating instructions or those supplied
with your tool or battery pack.
,, t he 0roon in0ic tor,i0ht is
.... BLINKING", the battery pack
is being fast-charged. Fast-
charging will automatically stop when the
battery pack is fully charged.
[I _}_[,} If the green indicator light is
*' "* "ON", the charger is plugged in
but the battery pack is not
inserted, or the battery pack is fully charged
and is being trickle charged.
Plug charger cord into your standard power
outlet. Before inserting battery pack, remove
protective cap, then insert battery pack into
charger (Fig. 8).
The charger's green indicator light will begin to
"BLINK". This indicates that the battery is
receiving a fast charge. Fast-charging will
automatically stop when the battery pack is fully
charged.
When the indicator light stops "BLINKING" (and
becomes a steady green light) fast charging is
complete.
The battery pack may be used even though the
light may still be blinking. The light may require
more time to stop blinking depending on
temperature. When you begin the charging
process of the battery pack, a steady red light
could also mean the battery pack is too hot or
too cold.
The purpose of the green light is to indicate that
the battery pack is fast-charging. It does not
indicate the exact point of full charge. The light
will stop blinking in less time if the battery pack
was not completely discharged.
When charging several batteries in sequence,
the charge time may slightly increase.
When the battery pack is fully charged, unplug
the charger (unless you're charging another
battery pack) and slip the battery pack back
into the tool.
I__1 To prevent fire or injury
when batteries are not in
tool or charger, always place protective
cap onto end of battery pack. Protective
cap, guards against terminal shorting.
I I=1 [_1;]
PACK
PACK
RELEASE TABS
t
-- PROTECTIVE
CAP
REDLIGHT
1
GREEN LIGHT
-13-