Web Management Interface - Dell PowerVault 35F User Manual

Configuring the PowerVault 35F: Dell PowerVault 35F User's Guide
Reboot
The reboot function restarts the PowerVault 35F. This will cause selected configuration options to take effect.
This will result in all current operations being interrupted. Do not reboot the unit during normal operation.

Web Management Interface

The PowerVault 35F has a special web-based management interface that allows for remote configuration of the unit.
This Web Management Interface uses any internet browser to manage and configure the PowerVault 35F. Although
the menu structure is different in the Web Management Interface than the serial and SNMP interfaces, the functionality
of each menu is exactly the same. In many cases, the Web Management Interface replaces the menu screens of the
serial and SNMP interfaces with pop-down menu options.
To use the web based management tool:
1. Connect an Ethernet cable to the back of the PowerVault 35F.
2. Boot up connected SCSI and Fibre Channel devices first.
3. After all the devices have gone through their power up routines, boot up the PowerVault 35F.
4. Turn on the host computer.
5. If you know the IP address for the PowerVault 35F (default is 1.1.1.1), bring up the host computer's web
browser. If you do not know the PowerVault 35F's IP address or would like to change the IP address, connect to
the PowerVault 35F using the serial connection and get the information from the Ethernet/SNMP
Configuration menu. See
6. In the web browser's address box, type in the IP address. If you have not changed the IP address from the
default, you will type 1.1.1.1. If you have changed the IP address previously, enter the new IP address. Once you
file:///C|/Users/rishi_sood/Desktop/35F/ug/config_2.htm[3/21/2013 11:16:19 AM]
Ethernet/SNMP Configuration for more information on this process.