Accessories; Checking Accessories - Fujitsu Plasmavision PDS4213W-H User Manual

ACCESSORIES

CHECKING ACCESSORIES

One connector One remote
cover control
Four screws Two ferrite cores
(screw A x 2, (with wire
screw B x 2) clampers)
Screw A
(10 mm)
Screw B
(20 mm)
HOW TO USE ACCESSORIES
Cable clampers
Use the supplied cable clampers to bind the display's signal or power cables. Use them as shown in the figure when mounting the display
on the wall, using the wall-mounting unit, or hanging it from the ceiling using the hanging unit.
When you run signal cables
downwards
Connector cover
When you finish binding the cables using the cable clampers, you need to attach the
connector cover to the display.
To do this, use nippers to cut out a section of the connector cover such that the cables can
be pulled out through that section. Then attach the cover to the display.
When attaching the connector cover, make sure that the upper and lower projections on
the cover fit properly into the corresponding sections on the display.
Information
Cables for connecting the display to external equipment are not supplied. Contact your dealer for more information on these products.
One strap
Two AA batteries
(for remote control)
Two ferrite cores Two wire clampers
(PDS4213W-H (PDS4213W-H
only)
When you run signal cables to the right
One user's manual
Manual
Two cable
clampers
only)
Projections (to be fit into corresponding
sections on the display)
Four safety
brackets
(types A x 2,
type B x 2)
Three power
cables
E-5