Table of Contents
Advertisement
2.1 Chassis cover
2.1.1 Removing the cover
1.
Use a Phillips screwdriver to remove the screw on each front end of the top
cover.
2.
Loosen the two thumbscrews on the
rear panel to release the top cover
from the chassis.
3.
Remove the screws on both sides of
the chassis.
4.
Firmly hold the cover and slide it
toward the rear panel for about half
an inch until it is disengaged from
the chassis.
5.
Lift the cover from the chassis.
2-2
Thumbscrews
1/2 inch distance
Chapter 2: Hardware setup
Advertisement
Table of Contents
