Error Messages - Samsung SCX 6322DN - B/W Laser - All-in-One Service Manual

4.7 Error Messages

Message
Authentication Failure
Cancel?
Yes
[COMM. Error]
Connection Error
Connection Failed
[Document Jam]
Door Open
Drum Warning
Enter Again
Duplex Jam
Open/Close Door
File Access Denied
File Name Exist
File Name Over Limit
Fuser Door Open
Group Not
Available
[Incompatible]
Invalid Server Address
Line Busy
Samsung Electronics
Meaning
The ID or password you entered is incorrect.
Your machine's memory has become full
while trying to store an original into memory.
The machine has a communication problem.
Connection with the SMTP server failed.
The protocol you have entered is not
supported or server port is wrong.
The loaded original has jammed in the ADF.
The front cover or rear cover is not securely
latched.
The drum cartridge is near the end of its life.
You entered an unavailable item.
Paper has jammed during duplex printing.
Login to the network server was successful.
However, access to the file on the network
server was denied.
The file name you have entered already
exists.
The file names you can use are from doc001
to doc999.
However, all file names are used already.
The fuser door is not securely latched.
You have tried to select a group location
number where only a single location number
can be used, such as when adding locations
for a Multiple Send operation.
The machine has received a fax from which
is registered as a junk fax.
The server address you have entered is
invalid.
The receiving fax machine did not answer or
the line is already engaged.
Alignment & Adjustments
Suggested solutions
Enter the correct ID or password.
To cancel the fax job, press the OK button to
accept Yes.
If you want to send those pages that have
been successfully stored, press the OK
button to accept No.
You should send the remaining pages later,
when memory is available.
Ask the sender to try again.
Check the server settings and the network
cable.
Check the protocol or server port.
Clear the jam.
Close the cover until it locks into place.
You should ensure a replacement cartridge in
stock.
Enter the correct item again.
Clear the jam.
Change the server settings.
Enter a different file name.
Delete unnecessary files.
Open the rear cover and close the fuser door
until it locks into place.
For the location of the fuser door.
Use a speed dial number or dial a number
manually using the number keypad.
The received fax data will be deleted.
Reconfirm junk fax setup.
Enter the correct server address.
Try again after a few minutes.
Service Manual
4-25