Chapter 3 Installation Requirements; Environmental Requirements; Temperature Measurement Points; Figure 3.1 Surface Temperature Measurement Point - Fujitsu MCM3064SS Product Manual

CHAPTER 3 Installation Requirements

3.1

Environmental Requirements

3.2 Mounting Requirements
3.3 Power supply Requirements
3.4 Connection Requirement
This chapter describes environmental, mounting, power supply, and connection
requirements.
3.1 Environmental Requirements
The optical disk drive must be installed in an environment complying with the
ambient environmental requirements defined in Section 2.1.3.

3.1.1 Temperature measurement points

While the drive is operating, the ambient temperatures measured 3 cm away from
the surfaces of the optical disk drive must satisfy the ambient environmental
requirements specified in Section 2.1.3. As for the surface temperatures during
operation, the contact temperatures measured at the points shown in Figure 3.1
must satisfy the temperature requirements specified in Section 3.1.2.
(a) Inside optical disk cartridge
Hole for inserting thermocouple
Figure 3.1 Surface temperature measurement point (1 of 2)
C156-E228-02EN
Opening of disk outer wall
Tip of thermocouple
3-1