Usb Mass Storage Device Configuration - Asus P5KPL-VM 1394 SI User Manual

USB Functions [8 USB Ports]
Allows you to disable or select the different values of the USB functions.
Configuration options: [Disabled] [2 USB Ports] [4 USB Ports] [6 USB Ports] [8
USB Ports]
USB 2.0 Controller [Enabled]
Allows you to enable or disable USB 2.0 controller. Configuration options:
[Enabled] [Disabled]
Legacy USB Support [Auto]
Allows you to enable or disable support for USB devices on legacy operating
systems (OS). Setting to Auto allows the system to detect the presence of USB
devices at startup. If detected, the USB controller legacy mode is enabled. If no
USB device is detected, the legacy USB support is disabled.
Configuration options: [Disabled] [Enabled] [Auto]
USB 2.0 Controller Mode [HiSpeed]
Allows you to configure the USB 2.0 controller in HiSpeed (480 Mbps) or Full
Speed (12 Mbps). Configuration options: [FullSpeed] [HiSpeed]
BIOS EHCI Hand-Off [Enabled]
Allows you to enable support for operating systems without an EHCI hand-off
feature. Configuration options: [Disabled] [Enabled]

USB Mass Storage Device Configuration

Allows you to configure the USB Mass Storage Class Devices.
USB Mass Storage Device Configuration
USB Mass Storage Reset Delay
Device #1
Emulation Type
USB Mass Storage Reset Delay [20 Sec]
Sets the number of seconds POST waits for the USB mass storage device
after start unit command. Configuration options: [10 Sec] [20 Sec] [30 Sec]
[40 Sec]
Emulation Type [Auto]
Selects the Emulation type. When set to Auto, USB devices less than 530MB
will be emulated as Floppy and remaining as hard drive. Forced FDD option
can be used to force a HDD formatted drive to boost as FDD drive to boot
as FDD. Configuration options: [Auto] [Floppy] [Forced FDD] [Hard Disk]
[CDROM]
2-20
[20 Sec]
HTS42404 OM9AT00
[Auto]
Number of seconds
POST waits for the
USB mass storage
device after start
unit command.
Chapter 2: BIOS setup