Duct Mounting; Step One: Select A Mounting Location; Step Two: Connect The Duct Nozzle - Honeywell HCM-631N - Quietcare 3 Gallon Owner's Manual

Duct Mounting

Before beginning Duct Mounting:
I have confirmed local codes for proper draining practices for hot water
I have chosen an installation location that meets the requirements on page 10
Follow these steps to mount TrueSTEAM directly to the supply duct of the homeowner's HVAC equipment.
STEP ONE: Select a Mounting Location
M29598
STEP TWO: Connect the Duct Nozzle
1
TrueSTEAM Humidification System 69-2285—01
1
2
3
4
2
3
M29599
Choose a location that has access to a cold
water supply pipe.
Select a vertical or horizontal surface on the HVAC
supply duct, with adequate clearances, where
TrueSTEAM can be mounted.
Make sure there is a 120 VAC electrical outlet
rated for the TrueSTEAM model being installed.
TrueSTEAM Required Minimum
Model: Circuit Capacity:
HM506 7 Amps
HM509 10 Amps
HM512 12 Amps
Ensure the location is near a drain with a high-
temperature water rating. Consult local plumbing
codes for proper drainage. If no main floor drain
is available, see "Other Plumbing Options" on page 15.
Slide the foam gasket over the nozzle.
Make sure the o-ring gasket is properly seated
in the groove.
Insert the duct nozzle into TrueSTEAM. Twist clockwise
to ensure a tight seal.
11