Fujitsu Eclipse CD1000 Owner's Manual page 27

Cd multi-source receiver
Hide thumbs Also See for Eclipse CD1000:
Table of Contents

Advertisement

Available languages

Available languages

Mode
Problem
Dead or weak
sound
Power does not
turn on.
Common
to all
Frequencies or
titles set in
memory are
deleted.
The remote
control does not
work.
Causes
Is the volume control up sufficiently?
Is the muting function in effect (MUTE)?
Is the fader or balance control set far to one
side?
Other probable causes include broken
audio-signal wiring or a faulty speaker.
Are there too electrical items installed and
causing a lack of power?
Other probable causes include a run-down
car battery, broken power or
interconnection wiring.
Has the car battery been disconnected for
repair or checked out?
Are there too electrical items installed and
causing lack of available power?
Other probable causes include run-down
car battery, broken power or
interconnection wiring.
Is the battery low?
Is the battery installed in reverse polarity?
Is direct sunlight hitting the remote control
light receptor?
Other probable causes include a
malfunctioning remote control.
If you have a question:
Remedial action
to take
Turn up the volume control.
Cancel the muting (MUTE)
function.
Readjust the fader and
balance controls to more
normal positions.
Have your dealer check the
problem.
Have your dealer check the
problem.
Have your dealer check the
problem.
Reenter them into memory.
Have your dealer check the
problem.
Have your dealer check the
problem.
Replace battery.
Reinstall the battery in the
correct polarity.
Use the remote control close
to the receptor.
Have your dealer check the
problem.
Refer to
page
21
21
21
17,
18
20
20
X
27

Advertisement

Table of Contents
loading

Table of Contents