How To Operate The Cd Player; About Compact Discs; About Brand New Cds - Fujitsu Eclipse CD1000 Owner's Manual

Cd multi-source receiver

Hide thumbs Also See for Eclipse CD1000:

Table of Contents

Available languages

How to operate the CD player

• The signal recorded on a compact disc is read by a laser beam, so nothing touches the disc surface.

A scratch on the recorded surface or a badly warped disc may cause deteriorated sound quality or

intermittent playback. Observe the following precautions to ensure high quality sound performance:

Rough Edges

Ballpoint pen

Rough Edges

Flakes

Recorded surface

• Do not leave an ejected disc in the disc slot for very long; the disc may

warp. Discs should be stored in their cases and kept away from high

temperature and humidity.

• Do not stick a piece of paper or tape on the disc. Do not write on or

scratch either side of a disc.

• Discs spin at a high speed inside the deck. Keep cracked or warped

discs out of the player to avoid damage to the deck.

• Avoid touching the recorded surface when handling a disc; handle

discs by their edges.

• You may notice that some brand new discs are rough around the

center hole or outside edge. Remove the rough edges with the side of

a ballpoint pen, etc. Rough edges may prevent proper loading in the

deck. Flakes from the rough edges may also stick to the recorded

surface and interfere with playback.

III

Table of Contents

Table of Contents